Winter Park, Florida  |  FL Lic. CFC1426719

Repipe Winter Park

Pinhole leaks, falling pressure, or rust in the water? We replace the supply lines in Winter Park homes in one permitted, pressure tested project, and we do it without tearing the house apart.

Call (407) 326-3056 Get an Estimate
80,000+Repipes Completed
10-YearWorkmanship Warranty
25-YearPEX Pipe Warranty
Since 2003Serving Central Florida

Start Here

Why Winter Park Repipes Come Up So Often

Winter Park has some of the oldest housing stock in Central Florida. The city dates to the 1880s, and the neighborhoods around Park Avenue, the chain of lakes, and the college still hold homes built in the 1920s through the 1950s, along with mid century ranches and later infill.

That range matters, because the plumbing inside those walls was installed in whatever material was standard the year the house went up, or the year it was last renovated. A 1930s bungalow, a 1960s ranch, and a 1985 build each fail in a different way and on a different schedule.

A repipe replaces the water supply lines throughout the house rather than patching one leak at a time. For the full service detail, see whole house repiping. For everything else we handle locally, see Winter Park plumbing services.

ScopeAll hot and cold supply lines
MaterialsPEX or copper
PermitsPulled and inspected by Shamrock
TestingPressure tested before close up
Workmanship warranty10 years
PEX pipe warranty25 years

Know Your Era

What Is Probably in Your Walls

Build year is the fastest way to narrow it down. It is not a guarantee, because plenty of Winter Park homes have been partially repiped during a renovation, but it tells us where to look first.

Pre 1960Galvanized Steel

Threaded grey steel pipe was standard in the oldest homes here. It rusts from the inside, which chokes off flow and tints the water. If a magnet sticks to the pipe and the house predates about 1975, this is likely what you have.

1950s+Copper

Copper replaced galvanized and is genuinely good pipe. It still has a service life. Decades of mineral heavy Central Florida water plus thin wall copper eventually produces pinhole leaks, often several in a short span once they start.

1978 to 1995Polybutylene

Grey flexible pipe used widely in Florida during that window. It fails from the inside with little warning, and it is the material insurers and buyers ask about by name. See polybutylene replacement.

1990s+CPVC

Rigid cream colored plastic. It works, but it grows brittle with age and heat, and a brittle CPVC line can split at a fitting when it is disturbed during other work.

2000s+PEX

Flexible and freeze tolerant, and what we install on most repipes today. Fewer joints inside walls means fewer places to leak.

MixedA Bit of Everything

Common in older Winter Park homes that have been renovated more than once. A kitchen redone in 1998 and a bath redone in 2015 can leave three materials in one house, joined at transitions that become the weak points.

Not sure what you have? Look at exposed pipe in the garage, at the water heater, or under a sink, and tell us the color, whether it is rigid or flexible, and whether a magnet sticks. We can usually narrow it down over the phone at (407) 326-3056.

Signs It Is Time

Repair or Repipe

One leak is a repair. The pattern below is a system telling you it is finished.

A Repair Is Enough When
  • It is the first leak the house has had
  • The failure is at a fixture, a valve, or an accessible connection
  • The rest of the system is sound pipe in good condition
  • Pressure and water quality are normal everywhere else
A Repipe Makes More Sense When
  • You have had two or three leaks in the same year
  • Water pressure has dropped across the whole house, not one fixture
  • Hot water runs rusty or discolored after the house sits
  • The home has polybutylene or galvanized supply lines
  • Your insurer has asked about the plumbing material
  • You are already opening walls for a remodel

How It Goes

The Repipe Process

The part homeowners worry about most is the disruption. Here is the honest version of what happens in your house.

STEP 01Walk Through and Estimate

We look at what material you have, how the house is laid out, where the runs go, and what access exists in attic and walls. You get a written price for the whole project before anything starts.

STEP 02Permit

We pull the permit with the City of Winter Park and handle the inspection process. Homeowners should not be filing their own paperwork, and unpermitted plumbing work becomes your problem at resale.

STEP 03Protect and Open

Floors and furnishings get covered. Access points are cut where the new lines need to run, kept as small and as few as the layout allows.

STEP 04Run the New System

New supply lines go in to every fixture, with shutoffs where they belong. Most homes keep water at the end of each working day.

STEP 05Pressure Test and Inspect

The system is pressure tested, then the inspector signs off before anything is closed up. That order matters.

STEP 06Patch and Clean

Access points are patched and the site is cleaned. Ask us during the estimate exactly where drywall finishing and paint stop, so there is no surprise at the end.

Wondering what it runs? Our cost to repipe a house in Orlando guide explains what drives the number for Central Florida homes.

Local Considerations

Permits, HOAs, and Older Winter Park Homes

Permits and Inspections

A whole house repipe is permitted work. Shamrock pulls the permit and coordinates the inspection as part of the job.

  • We file, you do not
  • Inspection happens before walls close
  • You end up with a documented, inspected system
  • That paperwork is what a buyer or an insurer asks for later

Winter Park permits are issued by the city rather than Orange County. Confirm current fees and turnaround with us when you book, since those change.

HOAs and Historic Character

Plenty of Winter Park neighborhoods have an association, and some homes sit in areas where exterior appearance is taken seriously.

  • Most repipe work is interior, so exterior review is often not triggered
  • Where an exterior wall, a slab, or landscaping is involved, tell us early
  • We can work to your association's hours and access rules
  • Send us any requirements your HOA has and we will work within them

Every association is different, so check your own documents rather than assuming. We are happy to provide license and permit details if your board asks for them.

Older homes also need a lighter touch. Plaster walls, original tile, heart pine floors, and finished attics all change how we route new lines. That gets decided during the walk through, not improvised on day one.

Quick Answers

Winter Park Repiping FAQ

How much does it cost to repipe a house in Winter Park?+

It depends on the size of the home, the number of bathrooms, whether it is slab or crawl space, the material going in, and how much access the layout allows. You get a written price for the whole project before work begins, and financing is available. Our repipe cost guide walks through what moves the number.

How long does a whole house repipe take?+

Most homes are a matter of days rather than weeks, and most keep water at the end of each working day. The honest answer for your house comes after we see it, because access drives the schedule more than square footage does. Older Winter Park homes with plaster walls or finished attics can take longer than a comparable newer build.

Do I have to move out during a repipe?+

Usually not. Most people stay in the house. There are stretches during the day when water is off, and there is noise and dust around the access points, so plan around working from home if you can.

PEX or copper, which is better?+

Both are good pipe and we install either. PEX is flexible, needs fewer joints inside walls, handles our mineral heavy water well, and costs less to install. Copper is rigid, long proven, and some owners prefer it for resale or for exposed runs. Our material comparison covers the tradeoffs in detail.

Do you pull the permit, or do I?+

We do. A repipe is permitted work, and Shamrock files the permit with the City of Winter Park and coordinates the inspection. Be cautious with any contractor who asks the homeowner to pull the permit, because that shifts responsibility for the work onto you.

Will repiping fix my low water pressure?+

If the cause is corroded galvanized pipe narrowing from the inside, then yes, and the difference is usually dramatic. If the cause is the pressure regulator, the municipal supply, or a single clogged fixture, a repipe is the wrong fix. That is why we diagnose before recommending one.

Repipe Winter Park

Stop Chasing Leaks

Tell us the age of your home and what the plumbing has been doing, and we will tell you whether you are looking at a repair or a repipe. Phone (407) 326-3056 to speak with our team, or use the contact form below and we will follow up to schedule your walk through.

Call (407) 326-3056 Use the Contact Form
☎ (407) 326-3056 Contact Form

Get Fast, Professional Plumbing Service From Licensed Experts

Our licensed plumbing professionals provide emergency response, leak detection, sewer replacement, water heater service, drain and sewer cleaning, repiping, and complete plumbing system repairs across Orlando and Central Florida. Submit your request and a member of our local team will contact you promptly to schedule service.. If you're experiencing a plumbing emergency, we're here to help 24/7. Call (407) 326-3056 now for immediate assistance.